Hi, group.
I'm hoping to learn what the problem is with the attached file. I have an E as my cutter. When I originally imported it into SCAL and cut, it cut fine, though I did not set my blade pressure deep enough. Yet, when I went back to cut it again, the file distorted (I made NO changes) and then shut down SCAL. Each and every time I tried to re-cut, it shut SCAL down. SO, I tried another file and it cut fine. Would one of you take a look at the file and tell me if you see something that I missed? It may very well be an issue with SCAL, but I thought I would try with the file itself first.
Thanks a bunch.

I tried your file with my E and it cut out with no problem. Heather M has advised me in strange situations to take it back into ink duplicate it and make a new file. Dunno if it will work for you but it has solved a few problems for me

Ok. I'll give that a try. Thanks!